| Number of stage: |
1 thru 6 |
| Inlet connection: |
28" (706 mm) flange, matches 125# ANSI |
| Outlet connection: |
24" (610 mm) flange, matches 125# ANSI |
| Operating speed: |
3570 rpm in direct drive (60Hz) |
| Lubrication: |
Oil type with constant level |
| Impeller diameter: |
36" (915 mm) |
| Impeller tip speed: |
562 fps (172 m / sec) |
| Drive: |
Direct drive or gear box |
| Vibration tolerance: |
1.25 mils peak-to-peak (4.5 mm /s) |
| Balance piston: |
On all stages with pipes connection |
| Shaft end: |
3" 3/4 (95 mm), inlet end drive standard |
| |
Materials of Construction |
| Heads, bearing housings: |
Cast iron FGL 250 |
| Tie rods: |
15/16" (24 mm) diameter
cold drawn steel A60 |
| Joint sealing compound: |
RTV IS502 Silicone |
| Seals (air): |
Carbon rings each end |
| Seals (gas): |
Four carbon rings each end
with inert gas injection |
| Bearing: |
Ball bearings 6320 C3 PER AFBMA B10 STANDARD |
| Shaft: |
Carbon steel 2 C 35 (stainless steel available) |
| Impellers: |
Fabricated aluminium AS10G-AG3M-AG4MC or cast aluminium 443 |
| Baffle rings: |
Stainless steel |
| Motor pedestal : |
UPN roll carbon steel |
| Base pads : |
Anchor bolts |
| Noise level: |
In compliance with OSHA standards
when machine is fully piped
(certified tests available) |
| |
|
