151 Series - Air & Gas

Technical Data

Number of stage: 1 thru 7 (cast) - 1 thru 8 (fabricated)
Inlet connection: 12" (305 mm) flange, matches 125# ANSI
Outlet connection: 12" (305 mm) flange, matches 125# ANSI
Operating speed: 3550 rpm in direct drive (60Hz)
Lubrication: Oil type with constant level
Impeller diameter: 25" (636 mm)
Impeller tip speed: 390 fps (119 m/sec)
Drive: Direct drive or gear box or V-belts
Vibration tolerance: 1.25 mils peak-to-peak (4.5 mm /s)
Shaft end: 2" 3/8 (60 mm ), inlet end drive standard
 

Materials of Construction
Heads, bearing housings: Cast iron ASTM A-48 Class 35B
Tie rods: 13/16" (20 mm) diameter
cold drawn steel A60
Joint sealing compound: RTV IS502 Silicone
Seals (air): Two graphit rings each end
Seals (gas): Four carbon rings each end
with inert gas injection
Bearing: Ball bearings 6313 C3 per
AFBMA B10 STANDARD
Shaft: AISI 1038 Carbon Steel or equivalent
Impellers: Fabricated aluminium ASTM 6061 /
Cast ASTM 360
Baffle rings: Stainless steel
Motor pedestal : Structural steel
Base pads : Korfund Elasto-rib or equivalent
Noise level:

In compliance with OSHA standards
when machine is fully piped
(certified tests available)